Page 1 of 1
B&S, VMI, Schmidt.......
Posted: Sun May 30, 2004 7:32 pm
by Davidrn1
are the 3301, and 3302 models of these horns all the same?
It seems that they are all made in the same factory.
However, I have heard that there are some differences between them. If so what are they?
Thanks for the info.
Posted: Sun May 30, 2004 9:09 pm
by CJ Krause
***
Posted: Fri Jul 16, 2004 11:39 pm
by Leland
PhilW. wrote: Also, the 3302 has a graduated bore .745-.827, and the 3301 only goes to .808. As a final note, the 3301 seems to have a smaller bell flare, but I have never seen one in real life, so the WWBW picture may be skewed.
The 3302's bore numbers, as far as I can tell, count the 5th valve, which is larger than the 4th. 1-4's bore sizes should be the same on both models.
The bell flare seems identical between the two versions as well. The B&S PT-2 is identical to the 3301, too.
Oh yeah -- the last WWBW picture I've seen is quite skewed. It's unfortunate, because it's a good-looking tuba.