Page 1 of 1
Valve Guide Installation
Posted: Sun Oct 28, 2007 5:43 pm
by Tubaing
The Valve Guide on my 119 year old Besson Eb just came off. It origionally had a metal one but years before I bought it, it came off somehow so I SUPER GLUED a plastic one on top. It worked great and smoothly for a year or maybe two. I plan on just installing it on the top of the piston like I did before but was considering using JB Weld instead of superglue. Would JB Weld be safe to use?
Posted: Sun Oct 28, 2007 6:24 pm
by Tubaing
the elephant wrote:Absolutely not. Take it to a shop or risk ruining it. Valve guides vary from horn to horn and this needs to be looked at by an experienced technician. What you need can probably be made in the shop or can be ordered and altered to fit from a generic or universal guide. This is not hard to do if you have the experience, the tooling and the parts at hand. It will not cost you lots of money. If you value this horn get it fixed properly.
Good luck.
The piece is made. It is a matter of installing it.
Posted: Mon Oct 29, 2007 8:31 am
by AndyL
Bob1062 wrote:I ended up using a small cut down nail to get through the concert. It worked so well I still have it in there a year and a half later!
Did you use a copper or brass nail? I'd be concerned about wear to the valve guide slot with any harder material.
Posted: Mon Oct 29, 2007 11:32 am
by windshieldbug
Bob1062 wrote:I lost a valve guide over a year ago. I was giving my horn a bath the night before my first big quintet concert when I noticed it missing (never again!)!
Consider the source! It was probably on his Bass Trombone!
(JK)