Posted: Sun Aug 29, 2004 2:21 pm
On bass tubas, I think the quint valve makes a lot of sense, particularly if it is a larger bore than the other four or five valves.
Page 1 of 1
Posted: Sun Aug 29, 2004 2:34 pm
I happen to play one horn with a flat whole step, and one with the major third. I'd say they work equally well with the exception of the 5234 combo on the former, which is as close as you can get to a low G on my F, but is still quite sharp and doesn't involve the slide that I'd have my hand on anyway (1st). Very inconvenient.y
Posted: Sun Aug 29, 2004 4:28 pm
***
Posted: Mon Aug 30, 2004 12:11 am
I'd vote if you listed a near-minor third.
I have mine pulled out enough to play low Eb (on a BBb) 4-5, and it works really nicely for a low E (or lowish B) (2-3-5) and an honest-to-goodness valved low B. Other pitches benefit, too, but those are the notable ones.
I have mine pulled out enough to play low Eb (on a BBb) 4-5, and it works really nicely for a low E (or lowish B) (2-3-5) and an honest-to-goodness valved low B. Other pitches benefit, too, but those are the notable ones.
Posted: Mon Aug 30, 2004 3:15 pm
I like the flat whole step fifth valve. However, the only reason that I like the flat whole step is that my MW 32 was equipped with it and now I am used to it.
Mark
Mark
Posted: Mon Aug 30, 2004 4:15 pm
The designs have been out there (from my gallery index):bbtubaman wrote:... right about the 6 valve but hard to find on anything other than F tubas.
B&S rotary tubas. 4 pages from a 1985 catalogue.(2608KB)
http://groups.yahoo.com/group/YorkMaste ... -tubas.pdf
Thumbnails:
http://photos.groups.yahoo.com/group/yo ... +catalogue
The last link even will lead you to a photo of the valve section of a 4+2RV BBb tuba.
The galleries are stored within the Yahoo group system. Membership required, but then it is open for all.
If you experience problems right after having joined, please go back to the original link.
Klaus
Posted: Mon Aug 30, 2004 5:26 pm
There's always the old French tuba system.
5 valve: 2, 1, 4, 5, 7 semitones
6 valve: 2, 1, 4, 5, 1, 7 semitones
5 valve: 2, 1, 4, 5, 7 semitones
6 valve: 2, 1, 4, 5, 1, 7 semitones
Posted: Mon Aug 30, 2004 5:28 pm
Oh duh...PhilW. wrote:Actually, if I am not mistaken, two flat whole steps is a minor third.Leland wrote:I'd vote if you listed a near-minor third.
Well, wait -- the 2-3 valve combination is a major third, but I'm looking for the equivalent of 1-2, or 1-1/2 steps, which would be the minor third. People might try to call it a flat whole step, but I think that it's way too flat to even consider the label "whole step".
My 5th is just a bit sharper than 1-2. That's how it tunes best if I play low Eb as 4-5.