TubeNet

Has anyone had a problem with Haggerty's Spray Polish, not spraying after being stored for a considerable amount of time?

I am talking about unused containers. I apparently made the mistake of stocking up on Haggerty's. None of the unused cans work, after being stored for a couple of years!

If it was previously used, I could understand the nozzle being clogged, but I am at a loss to explain this situation!

Anybody have experience with this?

I have some positive news to report:

I tried, once again, using those unfriendly cans of Haggerty's Spray Polish, and discovered that by GENTLY depressing the nozzle, I was able to coax some of them into working!

I was tending to mash the nozzle down before (mostly out of frustration! ), but by being a little patient, and not pushing the nozzle all the way down (perhaps only depressing it about 80%, or so), maybe a little wiggling side-to-side, I was able to get many of the cans to work, after all!

Thanks to all who responded!

Look up the 800 number on line give them a call they will replace your can.. I buy it by the case and had a few cans that did the same thing Haggert will made good for the bad cans.Hope this helps Thanks Harv.

Thanks, Harv! I'll give it a try.

Useful to learn that I was not the only one that experienced this; and thanks Harvey Hartman for the advice to call the 800 number for a remedy.

Z-Tuba Dude wrote:Has anyone had a problem with Haggerty's Spray Polish, not spraying after being stored for a considerable amount of time?

I am talking about unused containers. I apparently made the mistake of stocking up on Haggerty's. None of the unused cans work, after being stored for a couple of years!

If it was previously used, I could understand the nozzle being clogged, but I am at a loss to explain this situation!

Anybody have experience with this?

I had a couple of cans with malfunctioning valves, both new, and after short usage. I bought mine from a retailer.

I also bought some cans that stopped working from Allied Supply ..Allied gave me a refund.. The Last case I got from Haggerty now have a small beebee in the cans like spary paint cans do . I think the Co. Had some Bad cans. thanks Harv.

see above.

I haven't had that problem with the spray, but you might consider a technique used with spray cans of paint. After each use, turn the can upside down and spray just long enough for the stream to become clear. The cleans the airway of any material that can dry hard (paint or polish).