Page 1 of 1
Replacing wheels on MTS hard cases
Posted: Sun Jan 23, 2011 10:23 am
by JCradler
I've got an MTS hard tuba case and one of the wheel assemblies is beginning to let go where it is riveted into the case shell. It still rolls fine, but one day the other rivet will let go and the whole shebang is going to fall out. Has anyone had success replacing the whole wheel assembly? If so, where did you order the part?
Thanks,
JC
Re: Replacing wheels on MTS hard cases
Posted: Sun Jan 23, 2011 10:38 am
by Dan Schultz
Just replacing a rivet is usually not a problem. If you want to change the whole wheel assembly... checking with an MTS dealer might be helpful. Ohio Travel Bag has wheel assemblies to fit most cases.
http://www.ohiotravelbag.com/
Re: Replacing wheels on MTS hard cases
Posted: Sun Jan 23, 2011 12:31 pm
by JCradler
Boom, there it is! Found it. Tubenet earns its keep once again! Thanks!
JC