Page 1 of 1
Replacement Parts for K&M Tuba Stand (Non-Playing)
Posted: Wed Oct 26, 2011 11:59 pm
by Z-Tuba Dude
Hey folks,
I am missing some of the rubber/plastic caps from various parts of my K&M "resting" stands (I suspect the cat!).
I have tried to contact K&M directly, with no luck.
Anybody have any ideas as to where I can buy the replacement parts?
Thanks!
ztubadude@optonline.net" target="_blank" target="_blank" target="_blank" target="_blank
Re: Replacement Parts for K&M Tuba Stand (Non-Playing)
Posted: Thu Oct 27, 2011 12:48 am
by imperialbari
Black fabric tape over strips of foam may be the fastest and least frustrating solution.
Klaus
Re: Replacement Parts for K&M Tuba Stand (Non-Playing)
Posted: Thu Oct 27, 2011 2:22 am
by Ferguson
The US importer for K&M is Connolly Music:
http://www.connollymusic.com/" target="_blank
I may have a few of these small parts around my office. Look me up.
Best,
Ferguson
Re: Replacement Parts for K&M Tuba Stand (Non-Playing)
Posted: Thu Oct 27, 2011 11:44 am
by Mark
I've lost some of these too. Here is a more specific link:
http://www.allianceplastics.com/acorn-s ... lt-nut-cap. You only have to buy 1,000.
Re: Replacement Parts for K&M Tuba Stand (Non-Playing)
Posted: Sun Oct 30, 2011 12:51 am
by muttenstrudel
Moin guys!
Please specify "caps". I could try to get them over my music dealer. I've had already some good experiences with K&M, especially with a dealer at hand.
Re: Replacement Parts for K&M Tuba Stand (Non-Playing)
Posted: Sun Oct 30, 2011 8:42 am
by Z-Tuba Dude
Hi Muttenstrudel,
Thanks for the message. If you can hook me up with your dealer, that would be great!
I am actually looking to buy two
complete sets of "caps" (I have two stands).
Here is what I am looking for:
It looks like there are 3 different sizes of "nut caps" plus the leg end caps.
Thanks, a million! I hope it works out.