Page 1 of 1
Besson Tuba Brace
Posted: Tue Mar 12, 2013 5:44 am
by b.williams
Hello.
Do any of you repair people have a Besson tuba branch brace ( or one that will work) or know where to find one? Please see the attached picture. It is about 5/8 of an inch (15mm) wide.
002.JPG
Re: Besson Tuba Brace
Posted: Tue Mar 12, 2013 11:31 am
by Dan Schultz
Can you post a larger image... and... a picture of another brace that you would like the 5/8" one to look like?
Re: Besson Tuba Brace
Posted: Tue Mar 12, 2013 11:59 am
by b.williams
TubaTinker wrote:Can you post a larger image... and... a picture of another brace that you would like the 5/8" one to look like?
It will look like this only longer about 5/8 " in between.
Re: Besson Tuba Brace
Posted: Tue Mar 12, 2013 5:13 pm
by Dan Schultz
This is not off of a Besson and doesn't have round flanges. But... it looks similar and is 5/8" tall.
Send me an email with your address if you want it.
Re: Besson Tuba Brace
Posted: Tue Mar 12, 2013 6:21 pm
by b.williams
Email sent.
Thank you Dan.
Re: Besson Tuba Brace
Posted: Sat Mar 16, 2013 7:57 pm
by royjohn
I don't think it would be too hard to cobble one of these together from a post from another brace and some sheet brass. Would just need a tracing of the shape. . .there is another brace that looks like this on the horn, right?
Re: Besson Tuba Brace
Posted: Sun Mar 17, 2013 7:09 am
by b.williams
royjohn wrote:I don't think it would be too hard to cobble one of these together from a post from another brace and some sheet brass. Would just need a tracing of the shape. . .there is another brace that looks like this on the horn, right?
Right.
