Page 1 of 1
Bell protection
Posted: Sun Sep 15, 2013 3:15 pm
by Jerryleejr
Looking for a way to clip a mic to my bell, the clip is plastic but has some sharp teeth. Thought about putting a strip of tape on my bell but I'm afraid the adhesive will affect the finish. Also might use a small piece of sponge. Any other ideas???
JJ
Re: Bell protection
Posted: Sun Sep 15, 2013 3:40 pm
by sousaphone68
Rubber finger thimbles one on each jaw might work
Re: Bell protection
Posted: Sun Sep 15, 2013 8:08 pm
by Untersatz
most mic clips that are actually made for this purpose have some soft sponge
rubber pads inside the jaws or you could put some on it yourself.
Re: Bell protection
Posted: Sun Sep 15, 2013 8:25 pm
by GC
no-slip shelf liner
Re: Bell protection
Posted: Tue Sep 17, 2013 1:14 am
by Reptilian
GC wrote:no-slip shelf liner
this
Re: Bell protection
Posted: Wed Sep 18, 2013 2:00 pm
by luke_hollis
Why not put a strip of tape on the teeth?
Re: Bell protection
Posted: Fri Sep 20, 2013 12:13 pm
by fenne1ca
Either shelf liner or just a couple layers of gaffer/masking tape (light adhesive that won't leave residue).