Page 1 of 1
Re: Blokepiece solo cup with "0" and "1" shanks
Posted: Sun Jan 19, 2014 4:42 am
by Lectron
Hmmm......Might keep that old receiver on the conn then.
What is the exit diameter (outher) on an old brit. rec. compared to Am.?
Re: Blokepiece solo cup with "0" and "1" shanks
Posted: Sun Jan 19, 2014 3:52 pm
by Lectron
Do a recording of yourselves, and you'll (often) experience that the difference is more 'feel' than 'hear'
If it's close to 'feel' only, I'd bet the audience wouldn't her the difference and would put their money on
the one you preformed and felt best on
Re: Blokepiece solo cup with "0" and "1" shanks
Posted: Wed Feb 05, 2014 2:27 am
by Lectron
bloke wrote:
<shilling.hawking>
I used the new 0 ("zero") shank tonight to play the two soft passages in "New World". Crazy-soft entrances are easier (full-size F tuba) with this back-bore (a 7.4mm recessed throat, matched with a conservative exit bore).
</shilling.hawking>
