Page 1 of 1

Re: Which model of Winter case fits a PT6-P ?

Posted: Mon Apr 17, 2017 3:32 pm
by swillafew
If you build up a table of this kind of information, it will be an awesome resource here.

Re: Which model of Winter case fits a PT6-P ?

Posted: Mon Apr 17, 2017 5:45 pm
by Ferguson
The measurements are at the Jakob Winter website. They are not difficult to find:

http://www.jakobwinter.de/media/produkt ... 1301640172

-F

Winter Cases

Posted: Tue Apr 18, 2017 5:28 am
by Robert Tucci
Blokie,

By far the best case for the "B & S" Perantucci PT-6/P is model 2089K/3098. I worked this out with the tech staff at Winter years ago. Photo attached: the block for the top bow and filler on the other end are very important. For this we also made a bell-plug. This case has additional padding on the lower end. Removed, the case will accept the new "B & S" MR-P CC-tuba as well.
Image

Image

We have this in stock.

Bob Tucci

Re: Winter Cases

Posted: Tue Apr 18, 2017 6:10 am
by Rivercity Tuba
Mr Tucci,

Bloke asked about the PT 6P and you posted information for the rotary model. Will this case work for the Piston valve tuba, if not which case will work?


Robert Tucci wrote:Blokie,

By far the best case for the "B & S" Perantucci PT-6/P is model 2089K/3098. I worked this out with the tech staff at Winter years ago. Photo attached: the block for the top bow and filler on the other end are very important. For this we also made a bell-plug. This case has additional padding on the lower end. Removed, the case will accept the new "B & S" MR-P CC-tuba as well.
Image

Image

We have this in stock.

Bob Tucci