Hi, I just bought a used 5v Miraphone 186 CC, and played around a little. I found that the 5th valve was, instead of a flat whole-step, was actually equivalent to a 2/3 combination. As flat whole-step is standard, it is very hard to find one without digging around. Although, I could map it out myself, I was just wondering if anyone had a chart that could be of use.
Thanks!
Play on!
ZO Thunderbird 6/4 CC
B&S 3100WG "JBL Classic" 6/4 F
South Portland, ME
University of Maine, Music Performance & Music Education (instrumental)
I have seen that link before. It would be nice to see the same information presented like it would be in a book about playing an instrument. A note with a number under it, for example.
BBb Tuba with 4 Rotors -
TE-2110 (2009) + TE Rose
Mack 210 (2011) + Bruno Tilz NEA 310 M0
G. Schneider (Made in GDR, 1981?) + Conn Helleberg 120S
I earn my living as an Electrical Engineer - Designing Power systems for buildings
I've tried to learn C but after so many years it's hard to wrap your brain around the whole step difference, especially when you mainly play municipal band concerts.
peter birch wrote:there is one in the tips section at the top of the page
That chart is based on a 1-1/2 step 5th valve. The OP is looking for a chart with a >2 step 5th valve.
BBb Tuba with 4 Rotors -
TE-2110 (2009) + TE Rose
Mack 210 (2011) + Bruno Tilz NEA 310 M0
G. Schneider (Made in GDR, 1981?) + Conn Helleberg 120S
I earn my living as an Electrical Engineer - Designing Power systems for buildings
swillafew wrote:I have seen that link before. It would be nice to see the same information presented like it would be in a book about playing an instrument. A note with a number under it, for example.
Nothing stopping you from doing that yourself. Air's fingering spreadsheet is about as accurate and flexible sheet as you will find anywhere.