Page 2 of 2

Re: Intonation of C Valve Trombones

Posted: Fri May 31, 2019 7:36 am
by Worth
For anyone interested, this morning I cut 5mm off the second valve slide and about 15mm off the first valve slide. Rough finished, reassembled, and a big smile! I figure this bone is mine for the long haul so I'm not worried about resale, and it is now very much in tune with itself. The third valve slide I'll leave as is. I read on another forum that Harry James used to set his third valve slide out a bit and just leave it there. This simple modification was just the trick and now I can adjust the slides properly.
:tuba: