TubeNet

Hey Tubenet,

I have been borrowing a friends visualizer that is essentially a mouthpiece with the bowl cut away. Anyone know of where I can get one of these or who can cut away the brass to make it? I am looking for one that can go into the receiver like any regular mouthpiece.

clear kelly acryllic mouthpiece + hacksaw or dremel.

Dana Hofer will make you one from an old mouthpiece for $60. I had him make one from one of the back ups I had for my main mouthpiece so the rims would be an exact match. Works extremely well.

https://www.facebook.com/21057203900520 ... 664784386/" target="_blank

bloke wrote:Personally, I don't believe that the embouchure behaves in the same way without the resistance of the throat/back-bore/instrument, but stating this tends to "trigger" some people, so I'll use a very small font.

(Is very slightly triggered)

Marcinkiewicz has these - https://www.marcinkiewicz.com/mouthpiece-visualizers/" target="_blank

Have no experience either way, but the price is right:

https://www.hensonsmusic.me/cutaways

Thanks everyone, I think I have an idea of where to start.