WTB tall hard case ~43in !
Posted: Wed Jun 08, 2016 12:45 am
Seeking hard case for the 'tall model' B&S/VMI/Musica etc etc
This one is a 5V Rotary CC, stenciled 'Musica', but obviously B&S-made.
Also nearly identical in wrap, dimension, and trimmings to a 4V BBb 'Schneider' version that I have compared side-by-side. (right down to the doubled-up 4th valve loop)
Tuba size = bell ~16in, body height ~43in
I believe JW 2089 1/2W is the correct case, but prefer used. A JW Kaiser case might work, but of course the bell swims in there. Other similar would be considered if tall enough. too tight in a 186 or PT F tuba sized case (JW 2088). Prefer abs type shell over plywood or flight trunk.
Thanks !
This one is a 5V Rotary CC, stenciled 'Musica', but obviously B&S-made.
Also nearly identical in wrap, dimension, and trimmings to a 4V BBb 'Schneider' version that I have compared side-by-side. (right down to the doubled-up 4th valve loop)
Tuba size = bell ~16in, body height ~43in
I believe JW 2089 1/2W is the correct case, but prefer used. A JW Kaiser case might work, but of course the bell swims in there. Other similar would be considered if tall enough. too tight in a 186 or PT F tuba sized case (JW 2088). Prefer abs type shell over plywood or flight trunk.
Thanks !