TubeNet

Posted: **Wed Dec 27, 2017 10:03 am**

Application?

Posted: **Fri Dec 29, 2017 1:16 am**

YORK-aholic wrote:iiipopes: Well, it isn't a stock application. Its to join to pieces right after the dogleg, but before the first 180 bend...

Mark: Yes, that will be my fall back solution. Before that will be trying my hand at spinning one on my lathe. Now that I think of it... A piece of 1" ID brass pipe, hmmm... The outside contours of the other ferrules are very simple.

Please disregard until further notice.

Sorry, I don't know why I didn't think of that earlier.

you silly silly person, you

Posted: **Fri Dec 29, 2017 6:35 am**

Why not take a slightly smaller piece of tubing, anneal thoroughly, and hammer lightly over a mandrel until it's stretched to the size you want? Quick and easy.

TubeNet

WTB: approx 1.04 in. Ferrule - solution found

Re: WTB: approx 1.04 in. Ferrule

Re: WTB: approx 1.04 in. Ferrule

Re: WTB: approx 1.04 in. Ferrule - solution found