Full-length Upright bell
Forum rules
Reminder: "Go fund me" requests are not allowed and should be reported. All requests will be deleted. If you are Looking to trade an instrument, We are requiring all ads to have the following information. Approximate trade value, Brand, Model, and location (for instruments, not accessories)
Reminder: "Go fund me" requests are not allowed and should be reported. All requests will be deleted. If you are Looking to trade an instrument, We are requiring all ads to have the following information. Approximate trade value, Brand, Model, and location (for instruments, not accessories)
- Dan Schultz
- TubaTinker
- Posts: 10424
- Joined: Thu Mar 18, 2004 10:46 pm
- Location: Newburgh, Indiana
- Contact:
Re: Full-length Upright bell
Ideally... what is the diameter of the small end, the flare, and overall length need to be?
Dan Schultz
"The Village Tinker"
http://www.thevillagetinker.com" target="_blank
Current 'stable'... Rudolf Meinl 5/4, Marzan (by Willson) euph, King 2341, Alphorn, and other strange stuff.
"The Village Tinker"
http://www.thevillagetinker.com" target="_blank
Current 'stable'... Rudolf Meinl 5/4, Marzan (by Willson) euph, King 2341, Alphorn, and other strange stuff.
- Heliconer
- bugler
- Posts: 216
- Joined: Sun Jun 22, 2014 12:30 am
Re: Full-length Upright bell
Why not make a MTS extension to accompany the standard 1241 upright bell? Would probably cost a few hundred less.
A bunch of metal fart noise machines
-
- 4 valves
- Posts: 565
- Joined: Tue Mar 03, 2015 8:11 am
Re: Full-length Upright bell
5.25" would be near the base of most 4/4 bells, several inches up the stack. Most any should give you 20-24 in cut at that point.
-
- 4 valves
- Posts: 565
- Joined: Tue Mar 03, 2015 8:11 am
Re: Full-length Upright bell
well the standard 1241 bell is 6.25" tenon not 5.25". 5.25" would be somewhere in middle of bell stack. So if the bell is 12" and the 5.25" cut is 10" down the bell stack, that would be 22".