The fins on that thing remind me of JDAM.
Or the suddenly ubiquitous NK Bobsleigh...
Corking a Mute for a 2165 with a Tone Ring [bloke]
-
- 6 valves
- Posts: 4230
- Joined: Wed Jan 07, 2015 9:44 am
- Location: With my fellow Thought Criminals
Re: Corking a Mute for a 2165 with a Tone Ring [bloke]
I am committed to the advancement of civil rights, minus the Marxist intimidation and thuggery of BLM.
- Rivercity Tuba
- pro musician
- Posts: 243
- Joined: Fri Jul 20, 2007 5:21 am
- Location: In a van down by the river
Re: Corking a Mute for a 2165 with a Tone Ring [bloke]
Is this the horn Bloke put the new dog leg, tuning slide,4th valve sleeve and lead pipe? This horn plays better than any 2165 by a long shot. He was really on to something. One really neat thing is the 6th valve to lower sharp notes. Plays smaller but still puts out a ridiculous amount of sound. Hope you got a good deal for such a great horn!
-
- 3 valves
- Posts: 276
- Joined: Mon Oct 26, 2015 4:42 pm
- Location: Copenhagen, Denmark
Re: Corking a Mute for a 2165 with a Tone Ring [bloke]
So, right now the mute plays about 20¢ sharp, which bugs me a lot. It is easy to fix, though, but it is a nuisance. My other mute do not alter the pitch at all. Additionally, there is a dead zone starting around low Bb down to about low F where it is unstable and difficult to center.
You might want to lower the resonance frequencies of the mute by making the mute opening smaller in diameter, and longer. try to find a piece of plastic tubing (hardware shop plumbing tubes?) which fits inside the mute opening, and cork it on one end for tight fit. maybe some 15 cm long or start with 20 cm and shorten.
Making the opening smaller in diameter and longer (it really does not matter much if the tube is mostly inside the mute) pulls resonance frequencies down, and might correct your issue.
I have two pieces of tubing for my wooden straight, each one fitted for one of my Eb tubas, and was able to get decent intonation for both this way. This is a cheap experiment.
Rolling tones on a bass trombone DW straight and cup mute I did resolve by drilling three small holes of approx 5 mm diameter in the bottom plate of the mute. I never did try this on a tuba mute, though, so others might want to comment.
Yamaha YEB-321 Eb 4v TA tuba
Meinl-Weston 2141 Eb 5v FA tuba
Hirsbrunner Bb 3v TA compensated euph
Wessex Dolce Bb 3+1v TA compensated euph
Alto/tenor/bass trombones in various sizes/plugs
Meinl-Weston 2141 Eb 5v FA tuba
Hirsbrunner Bb 3v TA compensated euph
Wessex Dolce Bb 3+1v TA compensated euph
Alto/tenor/bass trombones in various sizes/plugs