Page 1 of 1
Bell measurement needed
Posted: Wed Apr 03, 2019 9:39 pm
by roweenie
I'm looking for the bell length on the Holton 340 or 345......if anyone out there has access to one, could you take a measurement off it for me?
The measurement I need (starting at the point where the bell exits the ferrule to the end of the bell), like so:
Many thanks in advance!
Re: Bell measurement needed
Posted: Thu Apr 04, 2019 1:23 pm
by roweenie
Sounds about right bloke, thanks (I suspected you'd come through.....)
The York 91 I measured has a 27" long bell, so you're definitely in the ballpark.
The Simonetti website lists the horn (his example, anyway) as having an overall height of 37 3/4".
Re: Bell measurement needed
Posted: Fri Apr 05, 2019 1:11 pm
by roweenie
Awesome guys, thanks for the information.
I know that those horns were made in small batches by varying individuals, most likely by hand, so it makes sense that lengths would vary some....
Re: Bell measurement needed
Posted: Fri Apr 05, 2019 11:41 pm
by roweenie
Thanks, elephant!
Re: Bell measurement needed
Posted: Sat Apr 06, 2019 9:26 pm
by roweenie
bloke wrote:roweenie wrote:Sounds...
...so et tu down the 6/4 rabbit hole...??
bloke "who, fortunately, found a way out"
No sir, not a rabbit hole, at least for me.
I have to honestly say that my experiences have been quite different than what you usually describe.