21J fixer

The Big Ben · Post by **The Big Ben** » Mon Apr 04, 2011 9:24 pm

Here's a 21J fixer. Missing the leadpipe and #1 valve. Typical dents. Not severely thrashed but has stuck slides, broken solder joints. Since it is a 21J, it has the upright bell which is in reasonable condition. No whangs but lacquer is 'aged'. It has potential to be fixed up or have its bell robbed for use on a 2xJ in better condition than this one....

http://cgi.ebay.com/ws/eBayISAPI.dll?Vi ... 089wt_1141" target="_blank

SousaSaver · Post by **SousaSaver** » Mon Apr 04, 2011 10:44 pm

The trouble with this is unless you have a 1st valve for one of these, or know someone who does you might have trouble finding one. You cannot use 20K valves in these because they are a different bore size and the guide pins aren't in the same place.

Mike-ICR · Post by **Mike-ICR** » Tue Apr 05, 2011 7:21 am

a few years ago pistons for these horns were readily available through Allied Supply. Something may have changed since. That bell is worth more than the body!

Dan Schultz · Post by **Dan Schultz** » Tue Apr 05, 2011 10:27 am

Mike-ICR wrote:a few years ago pistons for these horns were readily available through Allied Supply. Something may have changed since. That bell is worth more than the body!

As of a few weeks ago... Allied only had a few #2 pistons. They may be gone now.

tubatom91 · Post by **tubatom91** » Tue Apr 05, 2011 11:41 am

I have a full valveset for this lol

tubatom91 · Post by **tubatom91** » Tue Apr 05, 2011 1:02 pm

If I bought this tuba, I'd likely take the bell, strip and buff the body, insert piston #1, attach my front bell and sell a working nice tuba. If the valve casings are all messed up I would cut and paste my set into it and again sell with a forward bell.

bort · Post by **bort** » Tue Apr 05, 2011 1:57 pm

tubatom91 wrote:If I bought this tuba, I'd likely take the bell, strip and buff the body, insert piston #1, attach my front bell and sell a working nice tuba. If the valve casings are all messed up I would cut and paste my set into it and again sell with a forward bell.

...and add a leadpipe!

tubatom91 · Post by **tubatom91** » Tue Apr 05, 2011 2:05 pm

I have one of those in my locker here at school

The Big Ben · Post by **The Big Ben** » Tue Apr 05, 2011 3:26 pm

tubatom91 wrote:If I bought this tuba, I'd likely take the bell, strip and buff the body, insert piston #1, attach my front bell and sell a working nice tuba. If the valve casings are all messed up I would cut and paste my set into it and again sell with a forward bell.

Gopher it! If you do the work, you might make a little loot on the deal.

TubeNet

21J fixer

21J fixer

Re: 21J fixer

Re: 21J fixer

Re: 21J fixer

Re: 21J fixer

Re: 21J fixer

Re: 21J fixer

Re: 21J fixer

Re: 21J fixer