Autocad question
Posted: Fri May 12, 2006 4:20 am
Howdy folks...
I'm on a Mac, using Illustrator CS2. I have a DXF and DWG exported from some type of "CNC-type" setup, and I can't get them to open in Illustrator.
Is there anyone out there in Tubaland who might be able to crack these files open, perhaps with something like Autocad, and export to some type of vector-based format I could read?
Thank you very much...
...Dave
I'm on a Mac, using Illustrator CS2. I have a DXF and DWG exported from some type of "CNC-type" setup, and I can't get them to open in Illustrator.
Is there anyone out there in Tubaland who might be able to crack these files open, perhaps with something like Autocad, and export to some type of vector-based format I could read?
Thank you very much...
...Dave