Page 1 of 2

Posted: Tue Mar 25, 2008 7:44 pm
by oldbandnerd
:roll:

Here's the decoder website :
http://webnet77.com/cgi-bin/helpers/morse.pl

Re: ' understand?

Posted: Tue Mar 25, 2008 8:07 pm
by trseaman
bloke wrote:.. - .----. ... / -... --- ..-. ..-. / .- -. -.. / .. - .----. ... / .-- .... .- -- .-.-.-
Easy for you to say...

Yes there are too many polls...

Posted: Tue Mar 25, 2008 8:40 pm
by dwaskew
01001001 00100000 01110100 01101000 01101001 01101110 01101011 00100000 01101001 01110100 00100111 01110011 00100000 01100001 00100000 01110000 01101111 01101100 01101100 00100000 01100100 01100101 01110011 01101001 01100111 01101110 01100101 01100100 00100000 01110100 01101111 00100000 01101101 01100001 01101011 01100101 00100000 01110100 01101000 01100101 00100000 01110010 01100101 01110011 01110100 00100000 01101111 01100110 00100000 01110101 01110011 00100000 01100110 01100101 01100101 01101100 00100000 01100100 01110101 01101101 01100010 01100101 01110010 00100000 01110100 01101000 01100001 01101110 00100000 01101110 01101111 01110010 01101101 01100001 01101100

Posted: Tue Mar 25, 2008 9:02 pm
by Captain Sousie
01010111 01100101 01101100 01101100 00101100 00100000 01001001 01110100 00100000 01110111 01101111 01110010 01101011 01100101 01100100 00100000 01110011 01101001 01101110 01100011 01100101 00100000 01001001 00100000 01101000 01100001 01100100 00100000 01110100 01101111 00100000 01100100 01100101 01100011 01101111 01100100 01100101 00100000 01110100 01101000 01100101 00100000 01100101 01101110 01110100 01101001 01110010 01100101 00100000 01100010 01101100 01101111 01101111 01100100 01111001 00100000 01110100 01101000 01101001 01101110 01100111 00100000 01100010 01100101 01100011 01100001 01110101 01110011 01100101 00100000 01001001 00100111 01101101 00100000 01110100 01101111 01101111 00100000 01110000 01110010 01101111 01110101 01100100 00100000 01101111 01100110 00100000 01100001 00100000 01100111 01100101 01100101 01101011 00100000 01110100 01101111 00100000 01110101 01110011 01100101 00100000 01100001 00100000 01110100 01110010 01100001 01101110 01110011 01101100 01100001 01110100 01101111 01110010 00100000 01100110 01101111 01110010 00100000 01110100 01101000 01100101 00100000 01101111 01101110 01100101 01110011 00100000 01100001 01101110 01100100 00100000 01111010 01100101 01110010 01101111 01110011

Posted: Tue Mar 25, 2008 9:04 pm
by Captain Sousie
RGVjb2RlIHRoaXMhIEhhaCE=

Posted: Tue Mar 25, 2008 9:22 pm
by The Jackson
Captain Sousie wrote:RGVjb2RlIHRoaXMhIEhhaCE=
The "Hah!" is mine good sir as I have indeed decoded "this"!

Speaking of Morse code...


--. .... .--- --. .--- / ...- -.-. -.. --. .... -.. --. / ..-. -..- / -.. -.-- -.. ..- -.- ..- --. .... .. / .-.. .... .. --. .. .-.. --. / --. ...- / ..-. .... .--- ...- / --. .... .--- ...- / --. .... -.-. -.. / - ..- -.. ..-. .--- / -- --. ..- -.- --. / -.-- --- ..- / .... .- ...- . / -... . . -. / .... .- -.. / .- ... .... -.- / -.. .--- .... / .- / ... .--- / ..-. .-. / .... .---

Posted: Tue Mar 25, 2008 9:34 pm
by eupher61
realizing that code is no longer required for a ham. Was a sad day, wasn't it?

(no, I'm not licensed, but my dad had been listed since 1933, and my brother K0GYK since 1960 or so.)

Posted: Tue Mar 25, 2008 9:40 pm
by jhedrick
eupher61 wrote:realizing that code is no longer required for a ham. Was a sad day, wasn't it?

(no, I'm not licensed, but my dad had been listed since 1933, and my brother K0GYK since 1960 or so.)
Yes - but it's still much in use. CW (ham-speak for Morse Code) will get through when nothing else will. It's a bit like an out-of-tune sax (there's another kind?) cutting through everything else.

Posted: Tue Mar 25, 2008 9:59 pm
by Captain Sousie
The Jackson wrote:
Captain Sousie wrote:RGVjb2RlIHRoaXMhIEhhaCE=
The "Hah!" is mine good sir as I have indeed decoded "this"!

Speaking of Morse code...


--. .... .--- --. .--- / ...- -.-. -.. --. .... -.. --. / ..-. -..- / -.. -.-- -.. ..- -.- ..- --. .... .. / .-.. .... .. --. .. .-.. --. / --. ...- / ..-. .... .--- ...- / --. .... .--- ...- / --. .... -.-. -.. / - ..- -.. ..-. .--- / -- --. ..- -.- --. / -.-- --- ..- / .... .- ...- . / -... . . -. / .... .- -.. / .- ... .... -.- / -.. .--- .... / .- / ... .--- / ..-. .-. / .... .---
I am indeed impressed and yes, nothing.

Posted: Tue Mar 25, 2008 11:15 pm
by Rick Denney
eupher61 wrote:realizing that code is no longer required for a ham. Was a sad day, wasn't it?

(no, I'm not licensed, but my dad had been listed since 1933, and my brother K0GYK since 1960 or so.)
Not really. That was the day I was able to finally get licensed. I have tried on several occasions to learn code, and I'm still working on it. But life has never given me enough time to really pursue it. When the requirement was dropped, I and many others were able to join a hobby that was dying anyway (and probably still is, but not for that reason).

(Last night's project was shunting a bit of the audio signal going into the two op-amps that drive the speaker-level audio outputs on my Ten Tec Omni V transceiver. The objective--fulfilled--was to not have the audio driven to clipping by the time the AF knob was on 2. Later in the week, I'm redesigning the blown parasitic suppressor from one of the vacuum-tube anodes in my 600-watt RF amplifier. This is a good hobby for me and am active in it.)

That said, I can read about half of Bloke's message without cutting and pasting it into a Morse-code decoder, and someday that will improve. Now that I have my license, I'm more interested in code than I ever was before. CW is not on the way out. No need for sadness, even by CW fans.

Rick "KR9D" Denney

Posted: Tue Mar 25, 2008 11:46 pm
by SplatterTone
I learned code on a Vic 20 and Commodore 64. I've forgotten exactly how it worked, but there was a programming trick where you could print something to the screen (or was it read something ??), then make a call, and it was like you had pressed enter ... or something like that. So I wrote a simple BASIC program that would generate random alpha-numeric characters and play the beeps corresponding to the character. It printed the character to the screen in the same color as the background so that you could not see it. Then waited for you to press the key. If you pressed the wrong key, it would send it again. This worked well for learning the characters. At some point, it hits its limit as a way to learn because you can never have more than one character queued up in your brain.

Later, when the IBM PC took over, along came Super Morse which did about the same thing, plus a lot more.

Nothing beats getting on the air and conversing in code for learning it.

Alas, it has been at least 10 years since I was last on HF.

Posted: Tue Mar 25, 2008 11:54 pm
by SplatterTone
OK. So now there's four. And I dint use no stinkin' decoder.

Posted: Tue Mar 25, 2008 11:57 pm
by SplatterTone
It was a lame poll. There was no answer:
Whiskey and Peanut M&Ms.

Posted: Wed Mar 26, 2008 12:02 am
by SplatterTone
You can get whiskey flavored M&Ms?!
You're from Texas. I thought you knew.
RC Cola and peanuts.
Whiskey and Peanut M&Ms.

Posted: Wed Mar 26, 2008 12:18 am
by SplatterTone
Working on the Nut Cracker Suite.

Posted: Wed Mar 26, 2008 8:46 pm
by ken k
Drink more Ovaltine!?!?!?

Man what a waste.... :D
k

Posted: Wed Mar 26, 2008 8:58 pm
by SplatterTone
Think about it.
Did Steve Fossett have annual checkups? Probably.
Good behavior? As far as we know.
Fingerings? His kazoo playing was impeccable.
Whisky and Peanut M&Ms? NO!!!
So, where is Steve Fossett now?

Posted: Wed Mar 26, 2008 11:28 pm
by iiipopes
.... .- ...- .. -. --. .--. .-.. .- -.-- . -.. - --- --- -- .- -. -.-- --. ..- .. - .- .-. -... .- ... ... --. .. --. ... - .... . .-.. .- ... - ..-. . .-- -.-- . .- .-. ... --..-- --- -. ... --- -- . ...- . .-. -.-- - . -.-. .... -. .. -.-. .- .-.. .--. .- ... ... .- --. . ... .. ..-. .. -. -.. -- -.-- ... . .-.. ..-. ..-. --- .-.. .-.. --- .-- .. -. --. -- -.-- .-- .-. .. - - . -. .. -. ..-. .. -. --. . .-. .. -. --. ... .-. .- - .... . .-. - .... .- -. - .... . .- -.-. - ..- .- .-.. -- ..- ... .. -.-. .-.-.-

hmmmmmmmm

Posted: Thu Mar 27, 2008 11:43 am
by gjones7777

Posted: Thu Mar 27, 2008 11:59 am
by gjones7777