Page 1 of 1
would this be a good start to making my own F?
Posted: Fri Jul 23, 2010 2:37 am
by djwesp
Re: would this be a good start to making my own F?
Posted: Fri Jul 23, 2010 9:58 am
by Dan Schultz
I don't think so. There's already too much open bugle there. Even an Eb build might be a squeeze. I would think a CC would be in order. My guess is that this body was probably a 'mistake'.
Re: would this be a good start to making my own F?
Posted: Fri Jul 23, 2010 12:54 pm
by Kevin Hendrick
Looks like it was intended to be a Cerveny 681 C.
Re: would this be a good start to making my own F?
Posted: Sat Jul 24, 2010 12:49 pm
by The Big Ben
That was my thought the first time these came around last month. Unless a buyer had the entire German/Czech style valve section, it might be better used as a source for a bell and put the rest away for future uses.
Re: would this be a good start to making my own F?
Posted: Sun Jul 25, 2010 1:55 pm
by tclements
DUDE! I'd buy a set of Yamaha 822 valves and slam them suckers right on there! Go for it!!