]Bottom bow repair guestimate
Forum rules
Be kind. No government, state, or local politics allowed. Admin has final decision for any/all removed posts.
Be kind. No government, state, or local politics allowed. Admin has final decision for any/all removed posts.
-
76tbone
- bugler
- Posts: 21
- Joined: Wed Jun 22, 2011 9:01 pm
Bottom bow repair guestimate
Would any of you care to thoughtfully guestimate the cost of dedenting the bottom bow of an old Besson BBb. The damage is shown below. [UPS strikes again ]
]You do not have the required permissions to view the files attached to this post.
-
PMeuph
- 5 valves
- Posts: 1382
- Joined: Tue Nov 06, 2007 7:36 pm
- Location: Canada
Re: Bottom bow repair guestimate
Depending on the Tech... I would venture that this could set you back 250$ easily...They will have to disassemble the bottom bow, remove the the plate and the the guard wire and remove all dents, but the also have to either fix the wire or manufacture a new one...
Here are links from Dan Schultz's web page...
http://thevillagetinker.com/miraphone_1 ... repair.htm
http://thevillagetinker.com/shop_services.htm
He quotes $250 as a minimum....
Here are links from Dan Schultz's web page...
http://thevillagetinker.com/miraphone_1 ... repair.htm
http://thevillagetinker.com/shop_services.htm
He quotes $250 as a minimum....
Yamaha YEP-642s
Boosey & Hawkes 19" Bell Imperial EEb
Boosey & Hawkes 19" Bell Imperial EEb
-
Dan Schultz
- TubaTinker
- Posts: 10424
- Joined: Thu Mar 18, 2004 10:46 pm
- Location: Newburgh, Indiana
- Contact:
Re: Bottom bow repair guestimate
OUCH!
$250 might cover straightening things out but you would also need to add transportation costs both ways to a shop and also allow extra if refinishing is required.
UPS and FEDEX BOTH suck!
$250 might cover straightening things out but you would also need to add transportation costs both ways to a shop and also allow extra if refinishing is required.
UPS and FEDEX BOTH suck!
Dan Schultz
"The Village Tinker"
http://www.thevillagetinker.com" target="_blank
Current 'stable'... Rudolf Meinl 5/4, Marzan (by Willson) euph, King 2341, Alphorn, and other strange stuff.
"The Village Tinker"
http://www.thevillagetinker.com" target="_blank
Current 'stable'... Rudolf Meinl 5/4, Marzan (by Willson) euph, King 2341, Alphorn, and other strange stuff.
-
SousaSaver
- 5 valves
- Posts: 1133
- Joined: Sat Jun 26, 2010 5:19 pm
Re: Bottom bow repair guestimate
Where are you located? Might be able to help you.
-
76tbone
- bugler
- Posts: 21
- Joined: Wed Jun 22, 2011 9:01 pm
Re: Bottom bow repair guestimate
Bloke and BrSousa...I'm in the Tampa Bay area. Horn plays pretty darn well. It's a Besson 3V compensating fixed upright BBb. The horn has moderate denting on one of the interior pipes (next loop inside from the outer most loop) covering half the distance of the loop. Silver plate is very good throughout; but I do not mind if repairs take some of the plate off. I really am not so partial to that ball support thing on the bottom bow. Half of the bottom bow guard-rail is missing. The seller chipped in $150 to cover part of the bottom bow repair. Any advice? Thanks in advance.