TubeNet

Hello!

Looking for ANY Kanstul tuba rotor valve and casing. Hopefully someone has one lying around somewhere or knows someone that has one lying around somewhere.
It doesn’t matter when or what size. Any Kanstul tuba rotor will do.

Thanks!!
Norm

Knowing the bore size would help. Do you want the early rotor style or the later "CR" style.

It’s on the Model 80 F tuba. I can get you measurements very soon.
What’s an email for you and I can send pictures also.

Your help would be greatly appreciated.
Norm

Bore is .725

I don't have one. I was pointing out that you left out some pretty crucial information if you want help locating one of these. Just trying to help. There are several valves in different sizes.

Good luck!

Thanks for the input. I should have been more clear.
I’m looking for any Kanstul tuba rotor.
Any style or size would be great. I can make just about anything fit with the project I have going on, but it just has to be a Kanstul rotor and casing.

11annienorm wrote: ↑Sat Apr 03, 2021 9:04 am Thanks for the input. I should have been more clear.
I’m looking for any Kanstul tuba rotor.
Any style or size would be great. I can make just about anything fit with the project I have going on, but it just has to be a Kanstul rotor and casing.

What kinda project?

Restoration project. I’ll post on my page once I get the valves back from the platers.