WTB - King stuff (bell, valves)
Posted: Sun May 21, 2023 12:45 pm
One of you guys who has slapped a single piece york bell onto a King body must have one of these layng around.
Lacquered, unlacquered, silver, and/or ugly, are all ok. I need for it to have never have been smashed up, with the cosmetics being of no importance.
I am ONLY (as in nothing else at all, whatsoever) interested in the 19" upright King bell.
Also, I know this is a longshot, but I need a King .689" four valve set, with the cases, prisons, stems, buttons, upper and lower caps.
If you have a complete horn (2341 or 1241) that has been trashed but has good valves and a good 19" bell but that is not playable, I might want it. Please post up what you have and what you want for it. Photos are necessary of the bell and of piston surfaces. Again, the rest of the tuba can be dogmeat for all I care. Non-smashed 19" bell. Usable 4-valve cluster.
I am interested in any usable 2341 or 1241 "junk" too.
whatchagot???
Lacquered, unlacquered, silver, and/or ugly, are all ok. I need for it to have never have been smashed up, with the cosmetics being of no importance.
I am ONLY (as in nothing else at all, whatsoever) interested in the 19" upright King bell.
Also, I know this is a longshot, but I need a King .689" four valve set, with the cases, prisons, stems, buttons, upper and lower caps.
If you have a complete horn (2341 or 1241) that has been trashed but has good valves and a good 19" bell but that is not playable, I might want it. Please post up what you have and what you want for it. Photos are necessary of the bell and of piston surfaces. Again, the rest of the tuba can be dogmeat for all I care. Non-smashed 19" bell. Usable 4-valve cluster.
I am interested in any usable 2341 or 1241 "junk" too.
whatchagot???