Shires "Bonezilla" Bass Trombone
Posted: Sat Dec 31, 2016 12:38 pm
Hi Everyone,
I am going to start parting out my horn to sell but is still available at the $4,000 for everything! Prices listed below thanks for checking it out! I would prefer to ship only in the CONUS buyer pays shipping. This is a super unique horn and although not a tuba it is perfect for a tuba player looking for a good horn to use as a double. This bass trombone valve section instead of being the traditional .594" it is a whopping .626". Thanks for looking!
Components:
Bell- BII7GM with removable flare with a satin finish on the outside of the bell and buffed on the inside of the flare $1,000
Tuning Slide- BYC Raw brass (bass tuning slide with a yellow C bend crook) $250
Valve Section- Independent dual rotor .626 bore valve section with custom engraved valve caps $2,500
Leadpipe- B2 $200
Handslide- B.562/.578 with yellow brace tubes and an enlarged bass crook (standard inner diameter bore size for bass handslide crooks is .602 where as this crook's inner diameter bore size is .620) $750
I'm looking to get $4,000 for this beaut and I am also willing to do local pick up in a 100 mile radius of the Shires factory or I can ship the horn with the buyers choice of the shipping company.
pictures can be found at this link to the facebook post about this horn
https://www.facebook.com/groups/CustomV ... 0859131317" target="_blank
I am going to start parting out my horn to sell but is still available at the $4,000 for everything! Prices listed below thanks for checking it out! I would prefer to ship only in the CONUS buyer pays shipping. This is a super unique horn and although not a tuba it is perfect for a tuba player looking for a good horn to use as a double. This bass trombone valve section instead of being the traditional .594" it is a whopping .626". Thanks for looking!
Components:
Bell- BII7GM with removable flare with a satin finish on the outside of the bell and buffed on the inside of the flare $1,000
Tuning Slide- BYC Raw brass (bass tuning slide with a yellow C bend crook) $250
Valve Section- Independent dual rotor .626 bore valve section with custom engraved valve caps $2,500
Leadpipe- B2 $200
Handslide- B.562/.578 with yellow brace tubes and an enlarged bass crook (standard inner diameter bore size for bass handslide crooks is .602 where as this crook's inner diameter bore size is .620) $750
I'm looking to get $4,000 for this beaut and I am also willing to do local pick up in a 100 mile radius of the Shires factory or I can ship the horn with the buyers choice of the shipping company.
pictures can be found at this link to the facebook post about this horn
https://www.facebook.com/groups/CustomV ... 0859131317" target="_blank