Reynolds Upright Bell Question

Dan Schultz · Post by **Dan Schultz** » Fri Feb 13, 2015 11:23 am

To someone on The Forum who owns one of the BIG Reynolds tubas with an upright bell:

Please provide me with some measurements. Use a cloth tape measure and give me the circumferences where the stack enters the ferrules. Then... measure the distance between those two points. The attached image says it all:

Tubajug · Post by **Tubajug** » Fri Feb 13, 2015 1:54 pm

I'm afraid I can't help you, but just FYI, your post says you want circumference, but the image is asking for diameter. I assume it's the circumference you really want?

There's one of these on ebay right now, you could just buy and measure that one!

Reynolds Tuba

aqualung · Post by **aqualung** » Fri Feb 13, 2015 5:37 pm

easy as pi

Dan Schultz · Post by **Dan Schultz** » Fri Feb 13, 2015 6:18 pm

aqualung wrote:easy as pi

Someone 'got it'.

doublebuzzing · Post by **doublebuzzing** » Fri Feb 13, 2015 6:21 pm

Now that's a stovepipe of a tuba. Wow, that is tall.

Dan Schultz · Post by **Dan Schultz** » Fri Feb 13, 2015 6:24 pm

Tubajug wrote:I'm afraid I can't help you, but just FYI, your post says you want circumference, but the image is asking for diameter. I assume it's the circumference you really want?

There's one of these on ebay right now, you could just buy and measure that one!

Reynolds Tuba

Ultimately... I want the diameter. However... the circumference is a heck of a lot easier to measure!

TubeNet

Reynolds Upright Bell Question

Reynolds Upright Bell Question

Re: Reynolds Upright Bell Question

Re: Reynolds Upright Bell Question

Re: Reynolds Upright Bell Question

Re: Reynolds Upright Bell Question

Re: Reynolds Upright Bell Question