For an economic, solid, great sounding instrument, I cannot recommend a Besson/Boosey & Hawkes Imperial enough. I've built my career on it.
I've tried the Wessex, and it's exemplary... a great value for an "Improver".
I played a Miraphone C4 for 2 decades on my Imperial. However, I switched first to a Yamaha "Self" and then a Yamaha CB... but I would recommend those only to a very strong player.
But try instruments... lots! get to know what you prefer, not just what is recommended!
J.c.S.
EEb choice for 'improver' in UK
- J.c. Sherman
- 6 valves

- Posts: 2116
- Joined: Mon Apr 11, 2005 1:11 pm
- Location: Cleveland
- Contact:
Re: EEb choice for 'improver' in UK
Instructor of Tuba & Euphonium, Cleveland State University
Principal Tuba, Firelands Symphony Orchestra
President, Variations in Brass
http://www.jcsherman.net
Principal Tuba, Firelands Symphony Orchestra
President, Variations in Brass
http://www.jcsherman.net
-
Sprog
- lurker

- Posts: 8
- Joined: Fri Jul 03, 2015 4:28 am
Re: EEb choice for 'improver' in UK
Many thanks again, yes I've just been advised elsewhere that I should consider a used Imperial which ought to be about the same price as a new JP277 or Wessex.
From other posts on here I'm now confused and worried about the Parker/Fletcher cut (I have enough trouble not dropping flat above the stave as it is) and I certainly wouldn't want a ball on the bottom. Not sure I want to spend more than the price of my car on a tuba then have to get the hacksaw out !)
From other posts on here I'm now confused and worried about the Parker/Fletcher cut (I have enough trouble not dropping flat above the stave as it is) and I certainly wouldn't want a ball on the bottom. Not sure I want to spend more than the price of my car on a tuba then have to get the hacksaw out !)
- J.c. Sherman
- 6 valves

- Posts: 2116
- Joined: Mon Apr 11, 2005 1:11 pm
- Location: Cleveland
- Contact:
Re: EEb choice for 'improver' in UK
FWIW, I've never had to make the Fletcher cut to my Imperials.Sprog wrote:Many thanks again, yes I've just been advised elsewhere that I should consider a used Imperial which ought to be about the same price as a new JP277 or Wessex.
From other posts on here I'm now confused and worried about the Parker/Fletcher cut (I have enough trouble not dropping flat above the stave as it is) and I certainly wouldn't want a ball on the bottom. Not sure I want to spend more than the price of my car on a tuba then have to get the hacksaw out !)
Instructor of Tuba & Euphonium, Cleveland State University
Principal Tuba, Firelands Symphony Orchestra
President, Variations in Brass
http://www.jcsherman.net
Principal Tuba, Firelands Symphony Orchestra
President, Variations in Brass
http://www.jcsherman.net
- Peach
- 4 valves

- Posts: 701
- Joined: Thu Mar 17, 2005 8:42 am
- Location: London, UK
Re: EEb choice for 'improver' in UK
Imperial Eb's with 15" bell tend to have just fine pitch A = 440, but when B&H plonked the 19" bell on it flattened the tuba for basically everyone. Despite this they didn't change the design for a few years so folk started cutting the back bow - aka the (Phil) 'Parker Cut' - by just over an inch each side to bring the pitch up.
Peach
-
Sprog
- lurker

- Posts: 8
- Joined: Fri Jul 03, 2015 4:28 am
Re: EEb choice for 'improver' in UK
Thanks all for this great info, much appreciated