voltage

Be kind. No government, state, or local politics allowed. Admin has final decision for any/all removed posts.
Forum rules
Be kind. No government, state, or local politics allowed. Admin has final decision for any/all removed posts.
Post Reply
User avatar
iiipopes
Utility Infielder
Utility Infielder
Posts: 8579
Joined: Tue Sep 06, 2005 1:10 am

Re: voltage

Post by iiipopes »

1. How much current does the gadget use? If it uses no more than 4.5/5 of the rated current the adaptor can deliver, no problem. Most of these odd-voltage setups work because a nominal 1.5 volt alkaline battery actually delivers 1.6 to 1.7 volts when new, so that's actually 4.8 to 5.1 volts.

2. OTOH, most modern gadgets have some sort of circuit protection built in, so running the 6 volt side should not be a problem.

3. Finally, inexpensive adaptors are notorious for inconsistency. I would take a multimeter and check to see what the actual voltage at the tip really is, knowing that under load it will be slightly less. Then I'd use the setting that is closest to the 5 volt rating, either side.
Jupiter JTU1110
"Real" Conn 36K
User avatar
Tubaryan12
6 valves
6 valves
Posts: 2104
Joined: Sat Nov 13, 2004 7:49 am

Re: voltage

Post by Tubaryan12 »

Whenever a small electric item breaks and it is for some reason other than the adapter, I never throw away the adapters. I have a 5 volt, 500 mA adapter. What is yours? If it's a match, send me a pic of your connector end and we'll see if that matches as well. If so, to you it will go.
Marzan BBb
John Packer JP-274 euphonium
King 607F
Posting and You
User avatar
Tubaryan12
6 valves
6 valves
Posts: 2104
Joined: Sat Nov 13, 2004 7:49 am

Re: voltage

Post by Tubaryan12 »

My adapter has a 2.40mm outside diam. Run yours through the calipers to be sure. I couldn't tell from your post if you were estimating, or had actually measured them.
Marzan BBb
John Packer JP-274 euphonium
King 607F
Posting and You
Post Reply