Holton tuba parts wanted ! BB663MR

[Bessontubaplayer]

Hello ! I`m looking for a marching leadpipe and a 3rd valve slide and maybe a new concert leadpipe for a Holton BB663MR . My leadpipe is bent and my 3rd valve slide has a crushed crook on the bottom of the slide . The tuba is just like a Yamaha YBB 105 .

[Dan Schultz]

None of those parts will be a problem for a repairman to get from either Allied or directly from Yamaha. You might have to buy the whole slide assemblies to get the crooks, though.

[Bessontubaplayer]

None of those parts will be a problem for a repairman to get from either Allied or directly from Yamaha. You might have to buy the whole slide assemblies to get the crooks, though.

I`ve emailed lots of tuba repair places but none will email me back . thats why i posted a want ad on here .my little tuba playes just fine but i`d like it to look better .

[Bessontubaplayer]

I wanted my parts fixed in the first place . thats why i`m trying to find new parts (or parts not as bad off as mine) . but none of the so called repair shops will repair it .

[Daniel C. Oberloh]

I wanted my parts fixed in the first place . thats why i`m trying to find new parts (or parts not as bad off as mine) . but none of the so called repair shops will repair it .

Really?... wow. The repairs you mention are pretty basic for an average brass repair shop. Got to be someone close enough that can assist you, where are you located?

Daniel C. Oberloh
Oberloh Woodwind an Brass Works.
http://www.oberloh.com" target="_blank

[Bessontubaplayer]

I wanted my parts fixed in the first place . thats why i`m trying to find new parts (or parts not as bad off as mine) . but none of the so called repair shops will repair it .

Really?... wow. The repairs you mention are pretty basic for an average brass repair shop. Got to be someone close enough that can assist you, where are you located?

Daniel C. Oberloh
Oberloh Woodwind an Brass Works.
http://www.oberloh.com" target="_blank" target="_blank

I live in Tn . I think the closest repair shop is a 3 hour drive for me . I think .

[eupher61]

Well, over near Memphis there's one guy...up north a bit in Evansville there's a guy...Atlanta...Charlotte...3 hours maybe, but if no one near you wants to work with you, you'll have to make a trip. It would be well worth it, likely, for a number of reasons.

[WilliamVance]

If I was in Tennessee I would be excited to know that Bloke is in the same state and could tackle this for you if you contacted him and worked out a time and date. Just a suggestion.