Hi all- Just wondering if anyone could point me in the direction of finding a source for the length of tubing needed to produce a certain pitch i.e. an F tuba is 9 feet long there an F is 9 feet long... I'm working on a project for a class and our group would like to build an instrument like those used in the Blue Man Group. Thanks!
Justin
Pitch in terms of tube length
Forum rules
Be kind. No government, state, or local politics allowed. Admin has final decision for any/all removed posts.
Be kind. No government, state, or local politics allowed. Admin has final decision for any/all removed posts.
-
Chuck(G)
- 6 valves
- Posts: 5679
- Joined: Fri Mar 19, 2004 12:48 am
- Location: Not out of the woods yet.
- Contact:
Re: Pitch in terms of tube length
Go here:jbeish wrote:Hi all- Just wondering if anyone could point me in the direction of finding a source for the length of tubing needed to produce a certain pitch i.e. an F tuba is 9 feet long there an F is 9 feet long... I'm working on a project for a class and our group would like to build an instrument like those used in the Blue Man Group. Thanks!
Justin
http://www.bias.at/index_e.htm
Click "products" and download and install the Musical Calculator and then bore all your firends with useless knowledge.
-
DonShirer
- 4 valves
- Posts: 571
- Joined: Fri Mar 19, 2004 9:08 am
- Location: Westbrook, CT
Jbeish, if you want to delve a little deeper into this, you may want to check an elementary physics book. Many of the blue man instruments seem to be made out of cylindrical PVC tubing. The formula for the fundamental frequency (pitch) of a cylindrical pipe open at both ends is f1= c/2L, and for a cylindrical pipe closed at one end (as it would be if you buzzed it with your mouth) the lowest resonant frequency is f1=c/4L. In each case c is the speed of sound (about 1100 ft/sec at room temperature) and L is the length of the tube (plus a small correction of about the tube diameter to account for the expansion of sound waves near the end of the tube). A frequency of 440 Hz, 220 Hz, 110 Hz, etc. corresponds to a musical pitch of A. You can find frequency tables for other pitches in reference books.
You should be aware that tubas are not cylindrical pipes, and will have lengths differing from these formulas somewhat. If you are in a mood to experiment, just buy a PVC pipe from your local hardware store, buzz it and compare it with a piano. Cut lengths off to raise the pitch. If you use PVC elbows to fold up the pipes, be sure to include their interior lengths in your calculations. Have fun!
You should be aware that tubas are not cylindrical pipes, and will have lengths differing from these formulas somewhat. If you are in a mood to experiment, just buy a PVC pipe from your local hardware store, buzz it and compare it with a piano. Cut lengths off to raise the pitch. If you use PVC elbows to fold up the pipes, be sure to include their interior lengths in your calculations. Have fun!
Don Shirer
Westbrook, CT
Westbrook, CT
