An F tuba question

The bulk of the musical talk
User avatar
MaryAnn
Occasionally Visiting Pipsqueak
Occasionally Visiting Pipsqueak
Posts: 3217
Joined: Fri Mar 19, 2004 9:58 am

Post by MaryAnn »

Well, Roger, a bit of history. My friend bought his new from Dillon and mine used to be owned by Scott Mendoker, who traded it in at Dillon and I bought it from there.

MA, muddying the air again.
User avatar
Kevin Hendrick
6 valves
6 valves
Posts: 3156
Joined: Sat Sep 25, 2004 10:51 pm
Location: Location: Location

Posteriority complex ...

Post by Kevin Hendrick »

the elephant wrote:
MaryAnn wrote:. . . muddying the air again.
Muddy air? Eww . . .
Better "muddy" than "dairy"! (even if it's in London) :lol:
"Don't take life so serious, son. It ain't nohow permanent." -- Pogo (via Walt Kelly)
User avatar
windshieldbug
Once got the "hand" as a cue
Once got the "hand" as a cue
Posts: 11516
Joined: Tue Mar 01, 2005 4:41 pm
Location: 8vb

Post by windshieldbug »

(that hurt!!!) :shock: :D :D :D :D
Instead of talking to your plants, if you yelled at them would they still grow, but only to be troubled and insecure?
User avatar
jonesbrass
4 valves
4 valves
Posts: 923
Joined: Wed Dec 20, 2006 11:29 am
Location: Sanford, NC

Post by jonesbrass »

My Cerveny F is also built to be played in a much higher pitch (like the Germans do), but the tuning slide is about a mile long, so it's no problem to bring it down to A=440. Even quite a bit lower, if need be.
Willson 3050S CC, Willson 3200S F, B&S PT-10, BMB 6/4 CC, 1922 Conn 86I
Gone but not forgotten:
Cerveny 681, Musica-Steyr F, Miraphone 188, Melton 45, Conn 2J, B&M 5520S CC, Shires Bass Trombone, Cerveny CFB-653-5IMX, St. Petersburg 202N
User avatar
Steve Inman
4 valves
4 valves
Posts: 804
Joined: Fri Mar 19, 2004 11:48 am

AAAAaaaaaa !!!!!!

Post by Steve Inman »

windshieldbug wrote:
Roger Lewis wrote:I suspect this horn was built for distribution in Europe where the pitch center runs A=445 and even a lot higher. Many manufacturers make two different tuning slides, to match the pitch where the horn will be shipped. I think that this horn in question originated in Europe and then was sold to someone here without the slide alterations.
I thought so, too Roger, but I've got a 184 CC 'fone that had the same high pitch center. I thought all the domestic Euro horns were 'phones...
OKAY -- here's the question that's just BEGGING to be asked about now:

How much of the "dreaded low C" problem on rotary F tubas is due to the 4th valve tuning slide not being set properly, being too short, etc? That would surely make it hard to center the note, right?

Surely it's not that simple ..... surely?

:shock:
Steve Inman
Yamaha YEB-381 Eb
Conn 56J CC
Willson-Marzan CC Solo Model
Kokomo Chamber Brass
User avatar
Kevin Hendrick
6 valves
6 valves
Posts: 3156
Joined: Sat Sep 25, 2004 10:51 pm
Location: Location: Location

Re: AAAAaaaaaa !!!!!!

Post by Kevin Hendrick »

Steve Inman wrote:OKAY -- here's the question that's just BEGGING to be asked about now:

How much of the "dreaded low C" problem on rotary F tubas is due to the 4th valve tuning slide not being set properly, being too short, etc? That would surely make it hard to center the note, right?

Surely it's not that simple ..... surely?

:shock:
<serious>
That could well be part (maybe a large part) of the problem ...
</serious>

... and don't call me Shirley! :wink:
"Don't take life so serious, son. It ain't nohow permanent." -- Pogo (via Walt Kelly)
User avatar
iiipopes
Utility Infielder
Utility Infielder
Posts: 8580
Joined: Tue Sep 06, 2005 1:10 am

Post by iiipopes »

I played both of those (Them Basses and National Emblem) last weekend and had a blast -- pun intended. Because in both of those marches the fun parts are doubled with the bones & euphs, I can see where an Eb or F would help solidify the texture quite nicely.
Last edited by iiipopes on Sat Oct 22, 2016 11:08 pm, edited 1 time in total.
Jupiter JTU1110
"Real" Conn 36K
Allen
3 valves
3 valves
Posts: 404
Joined: Fri Mar 19, 2004 12:29 am
Location: Boston MA area

Post by Allen »

MaryAnn wrote:... A friend of mine who has a MW 182, basically identical to my 182, found that the tuning slide was way too short; that is, if you closed your eyes and centered the C in the staff and then looked at the tuner, it was 50 cents sharp. That's pretty sharp!! He got a tuning slide that brought the C in the staff down to pitch, and lo and behold the entire tuba became very, very playable. ...
I had the same problem with a Meinl Weston 32 CC tuba. The standard main tuning slide was for the European A=445 or somesuch. The solution: a call to Matt Walters at Dillon, and the purchase of what MW calls the long main tuning slide.

The Europeans practice ever-escalating pitch anarchy, no doubt heading toward A=500 or more! I imagine that in years to come, a European contrabass tuba will be the same size (and pitch) as a euphonium. On the Continent, they must be fans of Alvin & The Chipmunks.

Cheers,
Allen
User avatar
MaryAnn
Occasionally Visiting Pipsqueak
Occasionally Visiting Pipsqueak
Posts: 3217
Joined: Fri Mar 19, 2004 9:58 am

Re: AAAAaaaaaa !!!!!!

Post by MaryAnn »

Steve Inman wrote:
windshieldbug wrote:
Roger Lewis wrote:I suspect this horn was built for distribution in Europe where the pitch center runs A=445 and even a lot higher. Many manufacturers make two different tuning slides, to match the pitch where the horn will be shipped. I think that this horn in question originated in Europe and then was sold to someone here without the slide alterations.
I thought so, too Roger, but I've got a 184 CC 'fone that had the same high pitch center. I thought all the domestic Euro horns were 'phones...
OKAY -- here's the question that's just BEGGING to be asked about now:

How much of the "dreaded low C" problem on rotary F tubas is due to the 4th valve tuning slide not being set properly, being too short, etc? That would surely make it hard to center the note, right?

Surely it's not that simple ..... surely?

:shock:
Shirley, (ducking!) it is not that simple. If it were a 4th valve slide problem then the C in the staff would be in tune and not 50 cents sharp.

I did notice at one point that if I plulled the 4th valve slide waaaay out the c become more manageable, but then I couldn't use 4th valve for anything else. No, I trust my very capable and experienced friend on this one, and besides in about a month I"ll find out for myself on his tuba anyway.

Also, my 184 CC from the 1970's is definitely not sharp; it is quite well in tune except for that pesky E in the staff, which is remedied by using 1-2 for it. I'll query Matt about a long tuning slide for the 182 F; my friend had to have one custom made though.


MA
Allen
3 valves
3 valves
Posts: 404
Joined: Fri Mar 19, 2004 12:29 am
Location: Boston MA area

Post by Allen »

Bob1062 wrote:
Doc wrote:
In another thread, Doc wrote:I spent the most part of yesterday on my Firebird playing German blasmusik (matching octaves w/BBb),
You wuss, I played a bunch yesterday AT pitch on my little Eb. :lol:
But Bob, do you suppose your listeners heard a tuba sound? Even a trumpet can be played low. But, only a contrabass tuba makes a contrabass tuba sound down low. Smaller equipment down low tends to sound like a bass trombone or (contra)bassoon.

The following unbiased web site explains the differences among the various tubas:
http://www.bandparenting.net/tuba.html

Cheers,
Allen
User avatar
MartyNeilan
6 valves
6 valves
Posts: 4876
Joined: Fri Mar 19, 2004 3:06 am
Location: Practicing counting rests.

Post by MartyNeilan »

Allen wrote:The following unbiased web site explains the differences among the various tubas:
http://www.bandparenting.net/tuba.html
Cheers,
Allen
No disrespect to the author of that site. but...
Not so much tubas as overgrown Euphoniums, F Tubas were developed to make it easier for tubists to play the very high tuba parts common in French orchestral music.
:?: :?: :?: :?:
I kinda thought F tubas were the first tubas...
Adjunct Instructor, Trevecca Nazarene University
User avatar
jonesbrass
4 valves
4 valves
Posts: 923
Joined: Wed Dec 20, 2006 11:29 am
Location: Sanford, NC

Post by jonesbrass »

Doc, that's what the germans tend to do in their marches, too, play the parts in octaves. The F's really give some definition to the lines, and the blend between both horns is awesome.
I played my F on the Fourth with about 6 other C's and BBb's, and played most of the stuff as written in the contrabass register. It didn't have the breadth of sound that the contras have, but it had a clarity and focus that they generally don't. Definitely could keep up volume-wise. No real intonation problems, either. Gotta love the addition of a bass tuba to the section in a band.
Willson 3050S CC, Willson 3200S F, B&S PT-10, BMB 6/4 CC, 1922 Conn 86I
Gone but not forgotten:
Cerveny 681, Musica-Steyr F, Miraphone 188, Melton 45, Conn 2J, B&M 5520S CC, Shires Bass Trombone, Cerveny CFB-653-5IMX, St. Petersburg 202N
User avatar
iiipopes
Utility Infielder
Utility Infielder
Posts: 8580
Joined: Tue Sep 06, 2005 1:10 am

Post by iiipopes »

Indeed. A couple of seasons ago we had a German march/euph solo that had the tuba parts in octaves. I finally found an Eb to use to double the octaves and blend properly without getting in the way of the euph solo.
Jupiter JTU1110
"Real" Conn 36K
User avatar
windshieldbug
Once got the "hand" as a cue
Once got the "hand" as a cue
Posts: 11516
Joined: Tue Mar 01, 2005 4:41 pm
Location: 8vb

Post by windshieldbug »

Just to sidetrack the thread, has anyone ever tried a Firebird leadpipe on an older F? :shock:
Instead of talking to your plants, if you yelled at them would they still grow, but only to be troubled and insecure?
Post Reply