Besson Tuba Brace

b.williams · Post by **b.williams** » Tue Mar 12, 2013 5:44 am

Hello.
Do any of you repair people have a Besson tuba branch brace ( or one that will work) or know where to find one? Please see the attached picture. It is about 5/8 of an inch (15mm) wide.

002.JPG

Dan Schultz · Post by **Dan Schultz** » Tue Mar 12, 2013 11:31 am

Can you post a larger image... and... a picture of another brace that you would like the 5/8" one to look like?

b.williams · Post by **b.williams** » Tue Mar 12, 2013 11:59 am

TubaTinker wrote:Can you post a larger image... and... a picture of another brace that you would like the 5/8" one to look like?

It will look like this only longer about 5/8 " in between.

Dan Schultz · Post by **Dan Schultz** » Tue Mar 12, 2013 5:13 pm

This is not off of a Besson and doesn't have round flanges. But... it looks similar and is 5/8" tall.

Send me an email with your address if you want it.

b.williams · Post by **b.williams** » Tue Mar 12, 2013 6:21 pm

Email sent.
Thank you Dan.

royjohn · Post by **royjohn** » Sat Mar 16, 2013 7:57 pm

I don't think it would be too hard to cobble one of these together from a post from another brace and some sheet brass. Would just need a tracing of the shape. . .there is another brace that looks like this on the horn, right?

b.williams · Post by **b.williams** » Sun Mar 17, 2013 7:09 am

royjohn wrote:I don't think it would be too hard to cobble one of these together from a post from another brace and some sheet brass. Would just need a tracing of the shape. . .there is another brace that looks like this on the horn, right?

Right.

TubeNet

Besson Tuba Brace

Besson Tuba Brace

Re: Besson Tuba Brace

Re: Besson Tuba Brace

Re: Besson Tuba Brace

Re: Besson Tuba Brace

Re: Besson Tuba Brace

Re: Besson Tuba Brace