Engraving

cambrook · Post by **cambrook** » Thu Apr 23, 2015 10:21 am

Here are some photos of the engraving job that's just been completed on my York Eb project. The original design was all there but was very faint, it's great to see it clearly.

Thanks to Ray Hood at http://www.londonengraver.com

tylerferris1213 · Post by **tylerferris1213** » Thu Apr 23, 2015 10:22 am

It looks great! Will you put a coat of lacquer on?

Jay Bertolet · Post by **Jay Bertolet** » Thu Apr 23, 2015 4:34 pm

Really fine work, congrats!

PaulMaybery · Post by **PaulMaybery** » Fri Apr 24, 2015 12:21 pm

To anyone's knowledge are there such artists in the US capable of doing this type of work?
Would love to learn more of who is doing what.

T. J. Ricer · Post by **T. J. Ricer** » Fri Apr 24, 2015 4:46 pm

PaulMaybery wrote:To anyone's knowledge are there such artists in the US capable of doing this type of work?
Would love to learn more of who is doing what.

http://www.artisticengraving.com" target="_blank

Sherry does great work!

-T. J.

Pat S · Post by **Pat S** » Sat Apr 25, 2015 5:40 pm

T. J. Ricer wrote:
PaulMaybery wrote:To anyone's knowledge are there such artists in the US capable of doing this type of work?
Would love to learn more of who is doing what.
http://www.artisticengraving.com" target="_blank" target="_blank

Sherry does great work!

-T. J.

+1. She did a GREAT job on a Martin Committee trumpet that I sent her way a few years back.

TubeNet

Engraving

Engraving

Re: Engraving

Re: Engraving

Re: Engraving

Re: Engraving

Re: Engraving