It's not that big of a deal to spread the joint slightly, emory cloth both sides to clean it, apply flux separately, and solder it properly, sweating in solder as the flux boils away.
It's not that big of a deal to spread the joint slightly, emory cloth both sides to clean it, apply flux separately, and solder it properly, sweating in solder as the flux boils away.
That's a dentist's modus operandi?
K
Actually, dentists around where I live now use a composite epoxy filling material that is cured and hardened with UV light, then buffed to match the occlusion. Now, if he were to figure out how to snake his blacklight up through the tubing, he could epoxy it; otherwise, it's either duct tape or have a tech fix it properly.
